Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears,We are doing Migration, and have the following situation , SW2 (two switches stacked together) and SW1 (two switches stacked together) are connected with ACI (using the same Vlan) as follows , how make one link from each switch to be in blocked...
Dears,Kindly, we are planning to have 9410R chassis each one will have two SUPs. do this setup applicable and all SUP will join the VSS (SSO,RPR) as we found that "Cisco StackWise Virtual can be configured only on one supervisor module per chassis. Y...
Dears,I have 500 Apex, and 500 Plus and 500 Base, and I will migrate to model 3, which straight forward that those will give me 500 Primer. However, I found that "After October 31, 2023, those customers who have not migrated yet can continue to use B...
Dears,As below setup, what's the maximum sessions that can be handled at time. as the below table, it mentioned that if the 3615 working as the dedicated PSN will give 25K however when working as the PAN/Mnt will give 12.5K. So is this setup gives us...
Thanks for kind illustration , however there is no link between sw1 and sw2 , there are two links from each stack switches to aci , so the aci acts as hub and connected to each switch using 2 links so 2 links should be blocked or only one link from f...
thanks alot for your reply , using RVSTP , for the previous shared screen, if SW1 is root , can it has blocked port as I know all ports on root shall be in designated mode, so we are afraid that the following scenario happened that all ports on switc...
