Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
as show ip route tells i cannot find Cisco documentation for "forward metric" ... what is it ?our-6509->sh ip route 172.23.0.0Routing entry for 172.23.0.0/16 Known via "ospf 1", distance 110, metric 20, type extern 2, forward metric 21 Last update ...
Just now I have setup POLYCOM Viewstation H323 behind a PIX and in a "DMZ" under the FWSM ... it seems the Calling has started at the foreign POLYCOM, but the call cannot complete connecting. I have noted at the foreign POLYCOM that has picked up a ...
No matter LACP or PAgP is used, is it possible to do port aggregation on a Server with NIC 1 & NIC2 respectively connecting to different Switches which are then having the same uplink to higher level?as follows : - Server NIC # 1 ------ Switch #A --...
http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps6406/data_sheet_c78-584733.html"The Cisco Catalyst 3750-X Series Switches with LAN Base feature set can only stack with other Cisco Catalyst 3750-X Series LAN Base switches. A mixed stack o...
... what if , as i am doing , there exists old stack of 3750 of IPservices, now buying two 3750X LAN Base and wanting to stack onto ? The existing stack has IP routing turned on, too. What will happen ?
Dont do that... my 7911 gone dead after it Unplug the power cable from the phone, and then plug in the cable again. The phone begins its power up cycle.Immediately press and hold # while the Headset, Mute, and Speaker buttons flash in sequence. Relea...
1stofall, thanks. i'd aware of the type 2 ext as the route is from eigrp. The default metric is 20 alright. But it differs in forward metric when i redistribute the same route from another source (which is my original problem). The "forward metric...
Cisco Fixup is no good, ... have experience before about ESMTP see this note : Note: If you have an ESMTP server behind the PIX, you may need to turn off the Mailguard feature to allow mail to flow properly. Also, doing Telnet to port 25 may not work...
