Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I would like to understand if the 2 Default application lists that are predefined in vManage (Microsoft_Apps,Google_Apps) are updated in any way if so how often do they get updated, i would understand they require vManage to have INET access for ...
Hi, I am trying to build a SD-WAN lab using EVE-NG, so far the images for vManage and vSmart are booting ok but i cannot get to boot the image for the vEdge Cloud i have tried with 3 code version always with the same results, they are stuck in Initia...
Hi, I have a few vEdges in the warehouse that i would like to update before sending them to the remote site, i would like to download the OS image in a USB flash drive and connect it via the USB port in each vEdge, is there a guide for doing this?. I...
Hi, I need to track an IPSEC interface connected to a INET cloud provider, to verify an IP like 8.8.8.8 beyond the vEdge into the provider cloud, if 8.8.8.8 is not reacheable i need to flush the IPSEC default static route, something like this. ip ip...
Hi, I want to redistribute OMP routes to BGP, i have the doubt if all of the OMP prefixes located in the local vEdge will be redistributed to BGP or just the connected+static networks located in the vEdge. Also how can i restrict some OMP prefixes to...
A colleague had the same error message when trying to upgrade a ISR-1100-6G (Gnutella), the issue was that the incorrect Viptela OS image was being used, is easy to mistake the vEdge1000 with the ISR-1100-6G inside the cisco software download center ...
Hi
I had the same issue in a C1121-4P that STP was not working properly and was having loop problem while connecting 2 cables in the same VLAN using SVI, while running "show spanning-tree" nothing shows, after configuring "spanning-tree mode rapid-pv...
Hi
After having the cert invalid and sending to controller, I go to Configuration -> Devices, Search for the Cert and in the 3 dots select "Delete Wan Edge", after this is should be removed from any template, to then add the cert again.
Hi
Whenever I get this issue and I am short on time I do the "nuclear" option which is to "invalid" the cert and remove the device from the inventory, then I add the cert again and it will come as CLI mode.
