Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I got tested qos cbwfq using iperf and here is my configuration :class efmatch ip dscp efclass af21match ip dscp af21class af11match ip dscp af11policy-map testclass ef priority 512 police 512000 conform-action transmit exceed dropclass af11 b...
Hi,I have 2 asa 5520 firewalls including and 1 AIP-SSM-10 module in each of them. the configuration is set using active/active failover and context mode.Both of them run individualy the IPS module. The IPS is configured using inline mode and fail-ope...
Hi Im looking to replace a v440 with a newer sun hardware and I don t reaaly whcih model to choose, My licence supports 5000 devices running on solaris 10. my budget is £4000-6000. the questions are:is a T1000 strong enough ?are 2 cpu equivalent to ...
Hi,We have created an ipsec tunnel working from a vrf but not from the global routing table. Here is the scenario:crypto keyring tunnel vrf tunnel pre-shared-key address 0.0.0.0 0.0.0.0 key xxxxx!crypto isakmp policy 1 encr 3des authentication pre-s...
Hi,I use LMS 3.1I run exactly the same command but I get th following message:cwcli netconfig createjob -u admin -p password -devicefile /opt/CSCOpx/bin/test.list -commandfile command.file -policyfile policy.in -description "cwcli netconfig job" -mod...
Hi
Is there a way also to remove attached template on vEdge through Cli mode (without vManage). After controllers migration my vEdges have been detached from their template but still exist and present in the show system status ! so any config ch...
Hi Joseph,Since i m using ios 12.4(13)T, it should use HQF instead of pre-HQF. I understand your point to say that it is just a configuration limit so we can easily tweak it as needed up to 100%. However I don t understand why in books I see the fol...
Hi,Thank you very much it is the information i was looking for so long ...Is there any way to disable ot change this behavior or the default timer ?regards
