About ramram

ramram · 01-07-2020

Hi, I have a single 1841 router with two direct connected networks and I have configured NAT to allow the use of an internet gateway on both networks. I would like to be allow local devices on both networks to communicate with each other after imple...

ramram · 12-28-2019

Hi,I am trying to use a Cisco 1841 router to make a connection between two separate LANs which are directly connected. FastEthernet 0/0 is connected to network 10.80.1.0/24 and the interface received IP 10.80.1.135 IP via DHCP from a router on this n...

ramram · 01-09-2020

Hi Paul, In answer to your questions:Do you have users in the outside domain (10.80.130.0/24) aswell as your internet router, if so do you want connecton to all hosts between the nat domains? (inside/outside)Yes, there are users in the outside doma...

ramram · 01-09-2020

I can't seem to get this to work unfortunately, the 'ext' at the end provides invalid input so I tried ? in its place and it shows <cr>I tried the command without ext and it doesnt work either.

ramram · 12-30-2019

Thanks for both the replies, I have managed to get this working with the below entries:router(config)#access-list 1 permit 192.168.0.0 0.0.0.255 router(config)#ip nat inside source list 1 interface fastEthernet 0/0 overload router(config)# router(co...

Member Since	‎12-28-2019 03:25 AM
Date Last Visited	‎03-04-2020 12:17 AM
Posts	5

User Statistics

User Activity

How to enable NAT on a router and maintain two way communication

Router configuration to connect separate LANs

Re: How to enable NAT on a router and maintain two way communication

Re: How to enable NAT on a router and maintain two way communication

Re: Router configuration to connect separate LANs