Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to install VMWARE ESXi 4.1 on UCS C210-M2 but there is some problem with my RAID Controller or Hard Disk. can someone help me to troubleshoot.Regards,Faheem Ansari
Hello Everyone,I am getting some real time data from Electronic Devices over Serial Interface (RS232) and this Serial interface is conected to my Monitor Application System to view all information on real Time. I want to know, can I connect my Serial...
hello,I just configured E1 on my router to connect with local telco switch by configuring following parameters;controller E1 0/0/1pri-group timeslots 1-30description FMX_HUB!interface Serial0/0/1:15description FMX_HUBno ip addressencapsulation hdlcis...
Hi,QSIG is supported on Nortel CS1000E and other Nortel Platforms, following configuration will help you to configure Cisco VG..Site A:dial-peer voice 1 voip
destination-pattern 11.........
session target ipv4:9.8.7.6dial-peer voice 2 Pots
destinatio...
you can find documentation from Cisco.com under Support>Configure Tab, but i would to recommand some pure Cisco Techie fo this JOB.Regards,Faheem Ansari
if you need to connect PSTN with Cisco Router... you require 4 port FXO module, it could be VIC3-4FXO or VIC2-4FXO with IP Voice Services IOS. don't forget to rate the helpful answer Regards.
I think you are using NANP (North American Numbering Plan) in your Route Patterns so, if any dialed number start with “1”, CUCM will follow the E 164 standards of NANP i.e. (1 706 236 4455).if yes, recreate your Route Patterns and rate the helpful po...