Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am looking at setting up an industrial Ethernet network comprising multiple Cisco IE switches connected using Device Level Ring (DLR). The network uses multiple VLANs so the ports used for the DLR links will be configured as dot1q trunks.My q...
Hi,
I am interested in the NFVIS for UC hypervisor that was announced last years.
Does anyone know when this is actually going to be available? I saw a document that said support for UC would be in version 4.18.1 but I cannot see anything about such ...
Hi,
I have a customer with CUCM 14SU1 who have deployed three VG410 gateways. As the CUCM version does not support the VG410 in the gateways drop down list with any protocol (SIP, MGCP or SCCP) I configured a SIP trunk and Route Patterns on CUCM and ...
Hello,I have a few sensors which I am trying to set up MQTT for. I have followed the MT MQTT Setup Guide linked below but the sensor data does not seem to be getting to the broker.(https://documentation.meraki.com/MT/MT_General_Articles/MT_MQTT_Setup...
Hi,
I have a CUBE running IOS-XE 17.6.3a on an ISR4331.
When I SSH to the router and enter term mon I see debug information about SIP calls transiting the router even though all debugging is off.
Has anyone else seen this and, if so, do you know how ...
That sounds very odd. I would try doing reactive debugs for working and non-working ways of dialling and seeing whether I can spot any differences in variable values.Also what is doing the AA? - that seems to be the difference in calling methods - mi...
I have just noticed that NFVIS-for-UC does not support UCCX. This rules it out for quite a few customers and is a big omission given what Cisco are charging for it. Is this support road mapped? If yes when will it be available?The only option for sev...
James,Thanks for another valuable post. vSphere 8.x reaches End of General Support on 11 October 2027 and version 9.x is still not supported to run CUCM, UCCX etc.Is there any projected date for this support to be released? I am trying to position NF...
