Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi gurus,
has anyone implemented radius communication across NAT that translates the IP address of the radius client with one to one static translation?
In this scenario, Cisco Wireless LAN controllers are the clients of radius services that is pro...
Hello there,
As per the user guide, it is clear that Cisco Prime Infrastructure can send notifications to remote notification receivers.
Here is the excerpt from the User Guide
Configure remote event and alarm receivers who will receive notificatio...
Hello WiFi Gurus,
It is about Cisco's version Infrastructure Management Frame Protection ( Infrastructure MFP) but not about 802.11W which is Protected Management Frame (PMF).
In Cisco's document for code 8.0, it goes as
Infrastructure MFP is disabl...
Does anyone know what would happen to the failover interfaces(failover interface and failover stateful interface) if an global acl get applied to the firewall?Would the global ACL also attach to the failover interfaces?When the ASA runs in single con...
Hi I am facing an issuse of ssh accessing to the admin context of the standby ACE in a Active/Active Fault-Tolerance peer.I can ssh to the admin context of the active ACE. However, I cannot ssh to the admin context of the standby ACE.Should I also ge...
Hello Rasika,
Thanks for your reply.
I could not find option that allow to set Infrastructure MFP per WLAN in code 8.0 either. But, as the CIsco 8.0 configuration guide says that Infrastructure MFP could be disabled for select WLANs once it is enab...
Thanks Mohanak,
I had read the Cisco document at the link in your post. Have you checked it in WLC code 8.0?
Even in 8.0 configuration guide, it says that it is possible to enable/disable Infrastructure MFP for selected WLAN. But, I could not find ...
