Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have been seeing this concept of Twice NAT on cisco devices and Double NAT on Checkpoint devices. Somehow I am not able to understand how they work. Are they the same? Could anyone please explain whaht these concepts actually achieve? I am ma...
HelloWondering if any one has ever worked on the PIX Firewall Syslog server? The service keeps stopping with this errorEvent Type: ErrorEvent Source: Service Control ManagerEvent Category: NoneEvent ID: 7016Date: 21/07/2011Time: 8:46:55 AMUser: N/...
Hello,I am trying to configure identity nat from a packet originating on the DMZ to Inside. So i have created this configurationobject network identity_nat_1_245 host 192.168.1.245object network real_nat_1_245 host 192.168.1.245nat (dmz,inside) stati...
HelloI have a 1800 router and have configured dhcp client on the interface connected to the Internet. This basically gives out ip addresses which are private.I have another interface configured with two subinterfaces 192.168.247.0/24 and 10.128.0.0/2...
Hello,I have not managed to get the Monitoring to work on the ACS 5.1. This is an eval version. Advanced monitoring and reporting is installed on the ACS. This is my configuration on the Cisco Routeraaa accounting exec default start-stop group tacacs...
Hello Mike,Thanks for the reply. I have a question here. Traffic will get initiated from 10.1.1.1 and the ultimate destination will be 172.16.1.1 (translated destination address). The source address (10.1.1.1) will get hide natted to the interface ...
Hello JatinThis issue has been resolved. There is a known bug in ACS 5.1.0.44 that if you configure clock set on the CLI then the view-logprocessor will not start. You can view this by the command show application status acs. So I had to remove the c...
Looks like there is a known bug for this.CSCte95063After "clock set" view log processor goes to 'not monitored' state.Can anyone confirm that if i install the patch 5-1-0-44-4.tar.gpg, this issue will be resolvedThanks
