Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
OK, I have read many of the discussions in regards to the Cisco ISE GUI access problems. I rebuilt the server using 2.4 and after initial configuration i was able to log into the GUI interface and start the setup of the ISE server. I got to the point...
My corporate directory has a prefix that needs to be removed before it can be dialed on-site. rather than fix 4000 entries in the directory, how do i make a rule to remove the first 2 numbers that are dialed from the corporate directory. i have the p...
We are running CUCM 7.1 with 7960 and 7965 phones. The 7960 phones can access the corporate directory but the 7965's cannot. we get the error message "host not found." same error happens when we push the services button. configurations in 7960 almost...
We just upgraded from Call Manager 4.3 to Unified CM 7.1(2). Since the upgrade, all our phones show unregistered, and we cannot manage them from UCM. How do we fix this?Thank You!-MHAFBNET
We just upgraded from CallManager 4.3 to Communications Manager 7.1(2). All configurations carried over with Data Migration Assistant, but since the upgrade we cannot use call forwarding. We have attempted call forwarding from the phone via soft key,...
Thank you very much. I will try this today and let you know how it goes. I did do the show ports on both the ISE server that is no allowing HTTP connections and the ISE server that is allowing connections but I could not see 443 in either of them. I ...
Like I said in the original post. This had been working fine, the url does resolve to the correct ip and the ARP does point to the mac of the ISE. I can connect to the ISE server via SSH and i can ping the ISE server. This is not an ARP issue. As far...
"Apologies that I can't help you more. Cisco support helped me to get to that point before I figured out my problem when I got the error." You say that Cisco support helped you to that point then you figured out your problem. What was your problem?
try this. right click internet explorer/firefox and click run as administrator. then open the topology services. when it completes and says it needs to be restarted, close all your browsers, and logon the same way. once you get it up and running corr...
