Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,Just to verify using ones experience on the field, please take a look at the following scenario:I have a rather old installation with 5 single-mode 1242G access points.I would like to provide additional access using three 1131 LAPs, an 2112 ...
Just to clarify...SPA500S add buttons to a SPA phone, so I guess it does not require additional license.For example a UC560 can host 16 525G accompanied by SPA500 with no additional license packsregards
Dear all,The issue arises when the number of FXO required is more than the 12 supported by the UC560, or there more than 6 BRIs accordingly.What is, based on your experience, the most cost effective solution to support more than 12 FXO or 6 BRI.Pleas...
Hello,I have a 515 PIX running version 6.3(4) which has 3 interfaces. One for the local network (inside), one for internet access (outside) and one for vpn tunnels.The problem is that when i try to configure RRI i get:crypto map mymap 1 set reverse-r...
Well, I face a slightly annoying problem here.I am trying to establish a 5GHz connection between two 1240 AP connected to 5195 patch antennas (9.5dBi)One is configured as root bridge while the other is a non-root bridge.Although, in the same way I ha...
Hmm... Talking about SPA... I think SPA400 does the trick.Otherwise I need an ISR with voice interfaces which is somehow expensive... and then I start thinking of CCME.
I need all traffic originating behind fa0/1 to be routed via dialer1, as well as all inbound traffic to dialer1 to be forwarded to fa0/1.As if there are 2 routers (di0-fa0/0 & di1-fa0/1).
