LAP addition to existing environment

[akaliptos]

Dear all,

Just to verify using ones experience on the field, please take a look at the following scenario:

I have a rather old installation with 5 single-mode 1242G access points.

I would like to provide additional access using three 1131 LAPs, an 2112 WAP (single-controller deployment) and converting 1242s to lightweight.

The questions are:

1. Has anyone faced issues mixing up 1242 & 1131 using the same WLC?

2. Would it be a problem to add dual-band 1131AG LAPs or it would be safer to go with single-band ones?

Thank you all for your answers

[Surendra BG · Accepted solution]

Hi,

There is no problem in mixing 1131 and 1242 APs.. make sure the WLC supports enough number of APs.. In short.. No problem at all..

lemme know if this answered your question..

Regards
Surendra
====
Please dont forget to rate the posts which answered your question and mark it as answered or was helpfull

[akaliptos]

Yes you did!

Thank you very much

[Surendra BG]

Thank you for posting on CSC.. looking forward to see more posts!!

have a great day and happy holidays!!

Regards

Surendra