Hello,
I followed instructions here:
http://cucnw.blogspot.com/
however, when dialing intercom I get a busy signal, even with out a speed dial
Person A intercom number 200 speed dial set to 201 (person B) Cisco phone 7970
Person B intercom number 201 speed dial set to 200 (person A) Cisco Phone 7975
Partition and CSS set correctly, config applied
Cisco Unified CM Administration
System version: 9.1.2.11900-12
VMware Installation: 2 vCPU Intel(R) Xeon(R) CPU E5-2609 0 @ 2.40GHz, disk 1: 80Gbytes, 4096Mbytes RAM, Partitions aligned
Any help is appreciated, thanks