Hello everybody
Reminder : 2 cisco 2801 (VOIP1 : 192.168.1.12 and VOIP2 : 192.168.1.13) with 3 VIC2 2E/M and 1 PVDM2-32 in each router. Routers are connected directly via their fe0/0 interfaces. I want to connect an analog audio device (4 wires, 600Ohms) on each Voice Port (0/1/0) of each 2801. By using M lead of the port, the ports (local and remote) become 'in use' (Led ON). I can see the audio activity on the SYS/ACT Led on the router where the audio device is connected to when I'm speaking into the mic. But I don't have any audio on the remote output. Idem in the other direction. The same issue when the call is initiated from the other side.
Attached files contain the config of each router and the state of the call on each router.
PS. the call is made without speaking (during files capture)
If somedy has an genious idea ? :-)
Best Regards
Jo
