I am trying to rollout a site in Japan. I got struct while connecting the INS 1500 PRI from service provider(NTT) DSU.The jack used in NTT-ISDN DSU Look like RJ-45 but when we try to connect using RJ-45 connector we are unable to do so. Below is the photograph of Connector and female port.
Did any face the same issue? Need help on what type of connector it is and wire positions in connector .
Is this LTE card tied to specific provider such as Verizon or ATT. If I buy one of these for Verizon carrier, and later decide to move to ATT. Can I replace the software image to support ATT vendor? or will have to buy a new LTE card specific f...
Service flow verification and forwarding troubleshooting have just been made much easier with the introduction of the XR Embedded Packet Tracer framework.
The first platform on which this functionality is supported is the ASR9000, starting with rel...
6PE OverviewThe Cisco 6PE solution enables IPv6 domains to communicate with each other over an MPLS IPv4 core network. MP-BGP in the IPv4 network is used to exchange IPv6 reachability information along with a label for each IPv6 prefix announced. 6PE rout...
This document summarises various health checks that can be done on a Cisco VIM pod.
Cloud sanity checks the health status of network, storage and various openstack infrastructure components like mariadb, rabbitmq etc....