03-01-2010 07:47 AM
hello,
I'm testing in lab cube config for sip options ping. I have 2 callmanagers, 1 cube and 1 IMS(SP sip trunking) device.
in cube I'm using c2851nm-ipvoice_ivs-mz.124-24.T2.bin.
I can use the command voice-class sip option-ping 60 on dial-peer but with debug ccsip messages, I don't see anything.
any ideas ?
I can't use voice-class sip options-keepalive up-interval down-interval retry, command is not recognised by IOS. Which software do I need to take ?
Is this a licensed feature ? I thought 12.4T would be enough.
In fact I just want a mechanism to check if the remote device is SIP alive.
kind regards,
johan claes
ccie#5437
03-05-2010 01:48 PM
To monitor connectivity between Cisco Unified Border Element VoIP dial-peers and SIP servers to, use the voice-class sip options-keepalive command in dial peer configuration mode. To disable monitoring connectivity, use the no form of this command.
voice-class sip options-keepalive [up-interval seconds | down-interval seconds] [retry retries]
no voice-class sip options-keepalive
15.0(1)M | This command was integrated into Cisco IOS Release 15.0(1)M. |
03-06-2010 12:31 PM
hello all,
you need software 12.4-24 YB or 15.0 software with IPIPGW in.
then all the commands work fine.
However cisco website is not really clear which software is needed to activate
the cube features.
please read the book "SIP Trunking" from www.ciscopress.com, it's every $ worth.
kind regards,
johan claes
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide