Hello Experts,
Hope all of you are doing well.
I am new to E1 Configuration.I have a cisco 2951 router and i know the commands to configure E1 transportation and termination for voice.But have no idea how to configure E1 for data instead of voice.
Can anyone please help me with the configurations.Are there any change of commands needed to configure E1 for data.Given below is the my E1 termination configuration for voice.
Your help will be greatly appreciated.
Thanks in Advance.
card type e1 0 0 network-clockparticipate
wic 0 isdn switchtype
primary-ni
voice-card 0
voice-service dsp-reservation 65
dsp services dspfarm
controller E1 0/0/0
framing crc4/no crc4 clock
source line/Internal prigroup
timeslots 1-31
interface Serial0/0/0:15
no ip address
encapsulation hdlc
isdn switch-type primary-ni
isdn incoming-voice voice
no cdp enable
voice-port 0/0/0:15
dial-peer voice 19 pots
destination-pattern 3....
port 0/0/0:15
forward-digits all
