cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1456
Views
7
Helpful
3
Replies

How to add 2921 to Call Manger

gabiulici
Level 1
Level 1

Hiii,

I have a 2921 and is activated on the Lan, then I added the router to Call Manger from Device/Gateway/Add New/2921/MGCP/Domain Name/Module in Slot 0 ( NM-4WIC-MBRD ), then I activateda E1 to ( 0/0/0 ). How I can add the Gatway ( port -0/0/0 )  to a Route Group and what commands I have to do from the 2921 to be visible on the Call Manger.

On the Route Group/Find Device to Add to Route Group/ Device Name contains I don't see the ports from my 2921.


1 Accepted Solution

Accepted Solutions

Did you follow the steps to add the GW in CUCM metioned on the links?

--
Jorge Armijo

Please remember to rate helpful responses and identify helpful or correct answers.

-- Jorge Armijo Please remember to rate helpful responses and identify helpful or correct answers.

View solution in original post

3 Replies 3

Jorge Armijo
Level 4
Level 4

You have to configure few things on the MGCP GW:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a008017787b.shtml

http://www.cisco.com/en/US/tech/tk1077/technologies_configuration_example09186a00801ad22f.shtml

Then if you run into any issues:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00805a316c.shtml

HTH

--
Jorge Armijo

Please remember to rate helpful responses and identify helpful or correct answers.

-- Jorge Armijo Please remember to rate helpful responses and identify helpful or correct answers.

Can you help me with the proper steps and what I miss from the commands in order to add the router to call manager and activite de E1 ports etcccc.

conf t

username admin priviledge 15 password XXXX

line vty 0  4

transport input all

login local

no access group xx

interface gi0/0

ip address X.X.X.X  Y.Y.Y.Y

no shutdown

hostname ....

mgcp

mgcp call-agent x.x.x.x.

ccm-manager config server x.x.x.x

ccm-manager config

ip route 0.0.0.0 0.0.0.0  gateway class

WR

conf terminal

no access-list 23

no banner login

wr

conf ter

card type e1

control e1 0/0/0

pri group timeslots 1-31 service mgcp

isdn switch-type primary-net5

metadata-clock-part wic

no ip domain name yourdomain.com

wr

Did you follow the steps to add the GW in CUCM metioned on the links?

--
Jorge Armijo

Please remember to rate helpful responses and identify helpful or correct answers.

-- Jorge Armijo Please remember to rate helpful responses and identify helpful or correct answers.