cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1772
Views
0
Helpful
1
Replies
Highlighted

If possible ,Could you please tell me correct config ?

Hi Expert,

I need to ask for your advice.

Please look at the the following diagram.

Phone No.900 [AnalogPhone1]--[FXS]-[VGW1]-[E&M]===cable===[E&M]-[VGW2]-[FXS]--[AnalogPhone2] Phone No.100

I would like to make telephone call  from [AnalogPhone1] to [AnalogPhone2].

I did set the following.

---------------------------------------------------------------------------------------------------------------

VGW1:

!

voice-port 0/0/0

ring frequency 50

timing hookflash-in 500 150

description *** FXS ***

!

voice-port 0/1/0

operation 4-wire

type 5

cptone JP

timeouts interdigit 4

timing dialout-delay 180

description *** E&M ***

!

dial-peer voice 1 pots

description *** Analog Phone1 ***

destination-pattern 900

port 0/0/0

!

dial-peer voice 100 pots

description *** to E&M Port 0/1/0 ***

destination-pattern 1..

port 0/1/0

prefix 100

-----------------------------------------------------------------------------------------------------

VGW2:

!

voice-port 0/0/0

operation 4-wire

type 5

cptone JP

timeouts interdigit 4

timing dialout-delay 180

description *** E&M ***

!

voice-port 0/1/0

ring frequency 50

cptone JP

timing hookflash-in 500 150

description *** FXS ***

!

dial-peer voice 1 pots

destination-pattern 100

port 0/1/0

!

dial-peer voice 2 pots

description *** to E&M Port 0/0/0 ***

destination-pattern 9..

port 0/0/0

prefix 9

!

--------------------------------------------------------------------------------------------------------------

But, could not telephone between Analog Phone1 and  Analog Phone 2.

Maybe I think that It's easy miss config.

If possible ,Could you please tell me correct config ?

Thanks,

Best regards,

Takuro

1 REPLY 1
Highlighted

Hi Expert,

sorry.

I just solved now.

I changed operation 4-wire to operation 2-wire.

Thanks,

Best regards,

Takuro