Hi, I'm trying to connect an isdn phone directly to cme to a vic2-2bri-nt/te card. I configured the bri interfaces as following:
interface BRI0/1/0
no ip address
isdn switch-type basic-net3
isdn protocol-emulate network
isdn tei-negotiation first-call
isdn layer1-emulate network
isdn incoming-voice voice
isdn skipsend-idverify
line-power
!
interface BRI0/1/1
no ip address
isdn switch-type basic-net3
isdn protocol-emulate network
isdn tei-negotiation first-call
isdn layer1-emulate network
isdn incoming-voice voice
isdn skipsend-idverify
line-power
Which other configuration do I need on CME to make the isdn phone making a call? Should I need to configure a dial peer ? or anything else?
When I hang up the isdn phone i get a tone but on cme log i get this error: DisconnectText incompatible destination.
Please could anyone give me and advice?
thank you very much in advance.
regards