cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
482
Views
5
Helpful
3
Replies

problem on VIC2-2BRI-NT/TE Sometimes Can´t make calls

r.morales
Level 1
Level 1

I have configured this card, and some times Cant receive calls and some times can´t make calls, and to make calls again just receive a call, and now can make calls for little moment. What can be the problem?

interface BRI0/2/0

no ip address

isdn switch-type basic-net3

isdn point-to-point-setup

isdn incoming-voice voice

isdn send-alerting

isdn sending-complete

isdn static-tei 0

!

voice-port 0/2/0

compand-type a-law

cptone MX

dial-peer voice 100 pots

destination-pattern .T

direct-inward-dial

port 0/2/0

forward-digits all

!

dial-peer voice 3 voip

destination-pattern .T

progress_ind setup enable 3

voice-class codec 1

session target ras

ip qos dscp cs5 media

ip qos dscp cs5 signaling

!

3 Replies 3

iostres
Level 1
Level 1

Try "no dial-peer outbound status-check pots" in global configuration mode.

Regards,

Ivan

sdeltoro1
Level 1
Level 1

I have tried it and really worked, thanks a lot of

Well, you could rate my post if it was helpful ;-).

Ivan