02-03-2004 05:58 PM
I have an AS5350 voice gateway. How can I separate the different calls by E1 trunks ?
ex:
02T ---> the first E1
03T ---> the second E1
Thanks
02-04-2004 02:42 AM
Via dial-peers
dial-peer voice 1 pots
dest 02T
port
dial-peer voice 2 pots
dest 03T
port
02-04-2004 06:20 PM
Thank you for your reply and I am sorry I missed some information.
The AS 5300 uses ISUP to connect to TDM switch. That means we use the Cisco SS7 solution.
So there's no one D channel for each E1.
02-05-2004 03:02 AM
Well.
If you use SS7 solution so you must use some kind
of softswitch ( ala PGW ) so all dialplan you hold
there. So all call routing you must configure on
this softswitch. I donn't know SS7 wery well
but suppose that this is done via CIC.
02-05-2004 05:32 PM
Thank you very much
02-07-2004 12:41 PM
Jeremy,
How is your NAS connected to the PGW. Are you using RLM or are you backhauling the E1's. Either way if you need to treat each E1 differently, then each will need its own d channel, so that you can associate each one to a different RLM group or trunkgroup.
Please clarify your topology, and interconnection. I.E are you using the PGW in a "nailed" or "switched" mode.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide