Re: translation rule calling R2-H323

ereyes · ‎09-16-2004

I have a 5350 connected to pbx R2 E1 and ETH go to Voip h323 in the same equipment.

Call from R2 pbx into to 5350 without ANI , I need put ANI number in call to h323 with translation rule.

I config this:

translation-rule 50326700

Rule 1 any 1150326700 unknown unknown

voice-port 0:0

translate calling 50326700

echo-cancel coverage 16

compand-type a-law

cptone AR

description ATLANTIS LIFE

controller E1 0

framing NO-CRC4

clock source line primary

line-termination 75-ohm

ds0-group 0 timeslots 1-15,17-31 type r2-digital r2-compelled ani

cas-custom 0

country argentina

answer-guard-time 300

description Cliente Atlantis Life AX 1-slot 15-link 2

When i receive a call from R2 the go to H323 endpoint and display ANI private , not ani number.

Any can help

owillins · ‎09-22-2004

I am not sure I fully understand your question, but you could refer to the following doc to see if it helps.

sriram.g · ‎10-13-2004

Hi ,

You could use the new translation rules to get the ANI and so the translation rule would become like :

translation-rule 50326700

Rule 1 // /1150326700/

This would translate any number incoming from the PBX to 1150326700 and match that with the destiantion pattern in the outbound VOIP to destination.

Check this link :

This also has detailed explanation about translation rules.

I hope this helps.

Thanks

GS