We are working with Mediacom to connect via T1-CAS to an IAD2432 (E&M-wink-start). Is there a recommended configuration for this? Below is the snippet of the T1 controller config from the UC560:
!
controller T1 0/3/0
fdl ansi
cablelength short 133
ds0-group 3 timeslots 1-24 type e&m-wink-start
The IAD is configured with:
controller T1 1/0
mode cas
clock source internal
cablelength short 133
ds0-group 0 timeslots 1-24 type e&m-wink-start
!
Also, they’re asking about a 2-wire versus a 4-wire configuration. Does the UC500 require/ work better with one or the other?
Thank you for your time.
