10-09-2013 12:13 AM - edited 03-21-2019 07:50 AM
Hi all,
i have an issue with the CME GUI.
normally when we add new phones to the network the phone will appear on the GUI.but one of the phone is not appearing.but this phone is registered.can able to configure using CLI.what could be the cause?
thanks
kavi
Solved! Go to Solution.
10-09-2013 10:55 AM
Hi
i think you have a problem for max-ephones , please check the below URL.
https://supportforums.cisco.com/thread/2217816
Thank you
please rate all useful information
10-09-2013 10:55 AM
Hi
i think you have a problem for max-ephones , please check the below URL.
https://supportforums.cisco.com/thread/2217816
Thank you
please rate all useful information
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: