11-06-2009 04:23 AM - edited 03-21-2019 01:45 AM
Hi Again
After rebuilding my UC520, my AP521G is not working anymore. It is showing in the network topology but if I click configure it asks me for a username and password.
I have tried all passwords I would have used as well as the old password before resetting the router.
Is there a way I can reset this AP back to factory defaults so I can reconfigure it?
Thanks again
Solved! Go to Solution.
11-08-2009 05:21 PM
Default credentials for AP521 is Cisco/cisco (on the AP 521, an uppercase “C” is used for the first letter of the
username). Have you tried this?
Does it appear with a Circle in the ICON on Topology Map (signifying Standalone mode) or a triangle (signifying LWAPP)?
Let us know....
11-08-2009 05:21 PM
Default credentials for AP521 is Cisco/cisco (on the AP 521, an uppercase “C” is used for the first letter of the
username). Have you tried this?
Does it appear with a Circle in the ICON on Topology Map (signifying Standalone mode) or a triangle (signifying LWAPP)?
Let us know....
11-11-2009 03:57 PM
Hi thanks for your reply. The AP managed to work after I posted the thread, but I still couldnt access it. Now I have tried to access it, and the capital c is the trick. It must have reset back when I defaulted my UC520?
Anyway all good.
thanks again !
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide