06-28-2010 03:28 PM - edited 03-21-2019 02:43 AM
I've been trying to install the Office Manager 2 Beta, but keep running into the following message at 30% completion: "Error Reading Users"
After 5 to 10 minutes the install eventually times out and I get the following message: "Unable to Communicate with UC500"
I'm then able to configure the site settings, but still get the same message from any of the configuration tabs within Office Manager.
I've tried installing the software on two different XP w/ SP3 laptops, but get the same result on both.
Any help would be much appreciated.
Thanks,
Alex
06-28-2010 04:05 PM
Hi Alex,
I get this error on every install, no matter what.
I am thinking at this stage that in order for it to work correctly, the system needs to be a pure breed CCA configure machine with no CLI modifications what so ever, I have managed to get it to work once, but that was when the system was at factory defaults.
Cheers,
David.
06-29-2010 10:01 AM
Thanks David.
I set up a new UC540 using CCA alone, and the Office Manager associated to the unit without any issues.
Appreciate the help.
Alex
06-29-2010 12:55 PM
Hi David,
I did speak the a member of the Office Manager Beta development team regarding Office manager beta.
Office manager Beta assumes that you did setup the UC5XX via CCA. If the UC5XX is really out of band, Office Manager Beta will not work.
regards Dave
06-29-2010 01:31 PM
Hi Dave,
Thanks for the input, I learnt this the hard way.
Right now I have decided to give it a break as I was wrestling too much with it, I will give it another shot at another time.
Cheers,
David.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide