04-19-2013 01:57 PM - edited 03-21-2019 07:15 AM
I have a customer that wants to have the UC540 emulate their existing Norstar KEY system. They have 6 lines and 15 stations. I have already setup and tested a hybrid KEY system in my lab with FXO's as shared lines https://supportforums.cisco.com/docs/DOC-15755 . This works fine. The only problem is ican not select several phones to ring and several phones not to ring when a call comes in to the FXO trunk. Either all the phones have to ring or all the phones are silent ring, not a mix of both. Is there a way around this? Perhaps in CLI.
Solved! Go to Solution.
04-19-2013 03:25 PM
You can comfigure individual phones sharing a DN, with 's' button for silent ring. Note this is a CLI command, I don't know and can't answer if that can be done using CCA.
04-19-2013 03:25 PM
You can comfigure individual phones sharing a DN, with 's' button for silent ring. Note this is a CLI command, I don't know and can't answer if that can be done using CCA.
04-22-2013 10:08 AM
I'm not sure of the complete syntax. Could you give me an example config?
04-22-2013 12:57 PM
Type button and question mark, you will see all the possible choices.
04-22-2013 11:24 AM
I'm not sure of the complete sytax. Could you give me an example config?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide