SPA 6901 and SPA 508 with Configuration Assistant 3.0

[giactrovato]

Hi All,

I'm not able to set my SPA6901 and SPA508 phones with Cisco Assistant 3.0.

When I set the IP address of devices for search, are prompted user and password (Please enter your username and password for realm "Admin" on "192.168.3.251"). Which user and password I have to write? There are not user and password defined on my phones.

If I press ok there is the error: Unsupported device or firmware.

Thank you!

[Steven DiStefano]

What SWP you running?

8.1.0 is required

Steve

[giactrovato]

Thanks for the answer, but, probably I have lost something.

With SWP you mean software pack for Cisco hardware platform?

I have not Cisco platform hardware, I have phones only (I use it with Asterisk).

Is it possible to use Configuration Assistant to configure the phones, without Cisco platform?

Thank you!

[Steven DiStefano]

No, it is not.