SPA112 inbound ring tone too short

[info]

Hi there,

I use an SPA112 with a SnomONE PBX. On an inbound call the phone rings only for some milliseconds at the beginning of each ring signal.

Is there an option to adjust the ring signal length in SPA112 configuration?

Thanks a lot,

Philip

[Dan Lukes · Accepted solution]

It seems not to be PBX versus SPA112 issue but SPA versus yours-analog-phone issue. The ringing signal on POTS is driven by Ring_Waveform, Ring_Frequency, Ring_Voltage. You need to configure it according your's analog phone requirements.

[info]

Thanks a lot. It seems to work now. Somtimes, things are easy to solve if you know how...