- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-15-2015 09:35 AM - edited 03-21-2019 10:26 AM
Dear Support!
I purchased used a Cisco SPA2102-AN type VoIP router.
Unfortunately, I do not know the default user name and password (factory reset did it "# 73738").
So far, I tried:
user name: user, admin, admin
password: , admin, password
Thanks,
Zsolt
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-15-2015 03:14 PM
Hello tdzs_hungary,
I am sorry you are experiencing this issue. It sounds like you have a provisioned unit. A provisioned unit, to keep it simple, is basically a configuration that is sent or retrieved to/by the SPA2102 typically done by ITSPs. Due to this the previous provider and/or owner is the only person who will know the username and password as by default the SPA2102 does not have a username and password.
Further SPA2102s are end of life and end of sale and the current replacement is SPA122. If you want to look at getting an a current ATA.
Hope this helps,
Michael D.
If this post is helpful please rate or mark as correct.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-15-2015 03:14 PM
Hello tdzs_hungary,
I am sorry you are experiencing this issue. It sounds like you have a provisioned unit. A provisioned unit, to keep it simple, is basically a configuration that is sent or retrieved to/by the SPA2102 typically done by ITSPs. Due to this the previous provider and/or owner is the only person who will know the username and password as by default the SPA2102 does not have a username and password.
Further SPA2102s are end of life and end of sale and the current replacement is SPA122. If you want to look at getting an a current ATA.
Hope this helps,
Michael D.
If this post is helpful please rate or mark as correct.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-15-2015 11:10 PM
Thank you for your reply.
