06-15-2010 07:19 PM - edited 03-21-2019 09:27 AM
Hi there, i am trying to set up the following system
analog commander pbx ---> linksys8800 ---> internet
it seems to work fine when the internet is connected, but i would like it to failover and kick back onto the old ptsn line when the net is down.
i know this is possible with an asterix server but i dont know how to configure a normal old line on the spa8800? when i pull the ethernet cable it just sounds engaged.
i hope this is possible.
im a bit of a newbie as you can probably tell!. thanks in advance for your help.
06-16-2010 10:09 AM
This should work by default.
In the Phone 1 tab, it should show VOIP Fallback to PSTN, Auto PSTN fallback set to yes.
Then in your Line 1 tab, you can go to VoIP to PSTN Gateway setup and set your FXS Fallback DP. Default is None.
06-16-2010 06:12 PM
thanks very much for your help. it seems to be half working but i sitll have an issue wth the net side of things,
When the power is removed from the spa8800 it failsover to the ptsn line well,
but when i remove just the ethernet, it doesnt want to failover, just gives me an engaged signal... any ideas?
i have set the following settings to the line page thinking this might help but doesnt seem to change.
Make Call Without Reg: yes
Ans Call Without Reg: yes
Register: no
All i am getting is an engaged signal when the net is down..
i assume it doesnt need to register with a device as it is analog.
is there something i am missing here?
thanks very much for your help. almost there!
06-17-2010 09:42 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide