10-07-2011 07:45 AM - edited 03-21-2019 04:46 AM
Hi All,
I am unsuccessfully trying to set-up a remote teleworker phone. I have set up the SSL VPN full tunnel mode. Installed anyconnect package 2.5.3055. Using softwware pack 8.2. Phone is 525g2.
Each time I try to connect to the VPN I receive an error on the phone. The SSL VPN debug log shows the message "Can not select private key ( < fqdn of the UC540 > )".
I have disabled the firewall and tested with the same result.
Anybody know how to remedy this one?
Thanks!
10-07-2011 08:31 AM
Hello,
I would suggest trying to remove the trustpoint,then recreate, and re-enroll... This can only be done though CLI...
no crypto pki trustpoint TP-self-signed-xxxxxxxxxx <-- Replace xxxxxxx with number from config.
crypto pki trustpoint TP-self-signed-xxxxxxxxxx <-- Replace xxxxxxx with number from config.
enrollment terminal
subject-name cn=www.ansc-inc.net
revocation-check none
rsakeypair TP-self-signed-xxxxxxxxxx <-- Replace xxxxxxx with number from config.
cry pki enroll TP-self-signed-xxxxxxxxxx <-- Replace xxxxxxx with number from config.
NO
NO
Yes
Thank you,
Darren
10-10-2011 04:26 PM
Thanks Darren. That was enough to get it straightened out.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide