UC520 E1 R2 Config Using CCA.

[solucionesexpertas]

Hi, can somebody explain how to configure an VWIC2-1MFT-T1/E1 module via CCA in order to allow AXTEL digital trunk to work wich signaling is R2?

Señalización: R2 Modificado

Código de línea: HDB3

CRC4: Apagado

Tipo de señalización: CAS (CHANNEL ASSOCIATED SIGNALING)

Carrier shared those signaling settings.

Thanks in advance.

[Alexander Maroukian]

Hello Sir,

R2 cannot be configured with the CCA.

You should configure in CLI.

You may try to use the information from the following links:

www.cisco.com/c/en/us/support/docs/voice/digital-cas/12154-e1r2config.html

https://supportforums.cisco.com/docs/DOC-3604

HTH,

Alex

*Please rate helpful posts