cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
900
Views
0
Helpful
1
Replies

uc520 will not show booting from console

asfagan39
Level 1
Level 1

Hello fellow professionals,

I performed a reset to factory defaults after backing up the configuration and now the UC520 does not boot up. The port lights are solid green and access to the console port shows "C_< symbols". How can I resolve this issue?

Thanks in advance for your help!!!!!!

Sent from Cisco Technical Support iPad App

1 Reply 1

David Trad
VIP Alumni
VIP Alumni

Hi Antoine,

Can you fully power the system down, make sure the console cable is connected and your console software (Putty?) is active and ready to receive the feed, then advise if the UC starts to boot or not, if it goes into ROMON mode then we know what the problem is and there is a to resolve this problem.

Cheers,

David.

Cheers, David Trad. **When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *