cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
1093
Views
0
Helpful
1
Replies
Highlighted
Beginner

Manually adding ANL ephones into UC540

I have a UC540 that's missing its 4 anl ephones.

I tried adding one manually, however I can't seem to get it registered.

How does one go about manually creating the anl ephones?  What should the MAC address be?

Thanks!

1 REPLY 1
Highlighted

Do you use CCA?  In there its easy.

You navigate to Telephony > Ports and Trunks > FXS ports.

There you select either User Mode (gets a voice mail and feature code access and uses a license), FAX, or Common Area

To further configure "User Phone" go to Telephony > Users and Extensions > Users and Phones > User Extensions.
To further configure "Common Area Phone" and "Fax" go to Telephony > Users and Extensions > Users and Phones > Analog Extensions.

Creating a USER MODE:

voice-port 0/0/2

shutdown

dial-peer voice 3 pots

no description

no destination-pattern

service stcapp

sip-register

no corlist incoming

no translation-profile incoming

no dial-peer voice 1112 pots

voice-port 0/0/2

no station-id number

caller-id enable

no dial-peer voice 1112 pots

voice-port 0/0/2

no shutdown

Creating Common Area:

voice-port 0/0/1

shutdown

dial-peer voice 2 pots

no service

destination-pattern 302

no corlist incoming

no description

no translation-profile incoming

no sip-register

port 0/0/1
no dial-peer voice 1111 pots

voice-port 0/0/1

station-id number 302

caller-id enable

voice-port 0/0/1

no shutdown

In the case of the user Mode, and ephone gets created (this is an example of one created on my system):

ephone  42
device-security-mode none
mac-address 4C46.9D0F.2002 <-- bogus MAC address
max-calls-per-button 2
type anl

A Common Area or FAX dont get an ephone.

For User Mode you would then create the user and voice mail (ephone-dn and all its parameters as well as CUE voice mail box configuration).  Too many commands to list.