cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Welcome to the Cisco Small Business Community

Have a question? Click on a topic board below to get started in the community.

539
Views
0
Helpful
0
Replies
brian.russell31
Participant

UC520: Wireless Bandwidth vs LAN Bandwidth

Hi All,

Looking for your advice since Cisco TAC could not help me on my puzzle.

I have a UPC Internet 40Mb Down and 4Mb Up Static IP Connection.

Configured the UC520 Firewall set to Low inspection > When I do a speedtest while the laptop is connected to the UC520 via ethernet - I get the full bandwidth I would expect.

When I connect the laptop via wirelss and perform the same test I only get 17Mb Down and 4Mb up.

can anyone tell me why I have lost over 50% of my bandwidth?

I have copied the 2 interfaces below:

!

interface Dot11Radio0/5/0

no ip address

!

encryption vlan 1 mode ciphers tkip

!

ssid OceanCity_PL

!

speed basic-1.0 basic-2.0 basic-5.5 6.0 9.0 basic-11.0 12.0 18.0 24.0 36.0 48.0                                                                              54.0

station-role root

antenna receive right

antenna transmit right

world-mode dot11d country PL indoor

service-policy output Voice

!

interface Dot11Radio0/5/0.1

encapsulation dot1Q 1 native

bridge-group 1

bridge-group 1 subscriber-loop-control

bridge-group 1 block-unknown-source

no bridge-group 1 source-learning

no bridge-group 1 unicast-flooding

!

I see a service-policy about Voice - I dont use voice over wireless - Could this be causing the issue?

Thanks in advance

Brian

0 REPLIES 0
This widget could not be displayed.