Hello all
Am trying to put a NM-2CE1T1-PRI card on my 2651XM router. After inserting the card, am able to see the card getting recognised on the router, but have problems seeing it on the running config. I have used all 12.3(13) IOS ie IP plus, IP base, IP voice, and also 12.3(6) and all other IOS...
The show version, show running & show diag outputs are attached. when booting the router, i get a message:
2 Channelized (E1 or T1)/PRI port(s)
32K bytes of non-volatile configuration memory.
32768K bytes of processor board System flash (Read/Write)
Slot is empty or does not support clock participate
WIC slot is empty or does not support clock participate
Am sure there is no prob with the IOS or the hardware.. am not able to use the command network-clock-participate slot 1 or network-clock-participate wic 0...
Can anyone suggest please ??
Raj
