10-25-2011 11:20 PM
Hi Expert,
I use PIX 8.0(4) and ACS 4.2 for VPN authentication. I got error as below even I'm able to ping to ACS server from PIX
RADIUS_SENT erver response timeout
RADIUS_DELETE
ERROR: Authentication Server not responding: No error
I tested aaa command from PIX and check configure on ACS (key and IP address) include restart ACS. The output still timeout and not responding from server. I have no idea why?
PIX config:
=========
aaa-server AAA-VPN protocol radius
aaa-server AAA-VPN (MANAGEMENT) host 172.20.0.9
key xxxxxxx
tunnel-group CGS-DR type remote-access
tunnel-group CGS-DR general-attributes
address-pool VPN-POOL
authentication-server-group AAA-VPN LOCAL
default-group-policy GR-CGS
Thanks
10-26-2011 02:39 AM
Please post full PIX config here. It will e helpful. Also check if there is no devices between them that can block udp 1812 or 1645
___
HTH. Please rate this post if it was helpful. If this solves your problem, please mark this post as "Correct Answer"
10-26-2011 03:57 AM
Hi,
The issue was cleared by re-install ACS. Thanks for your feedback
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide