Anyconnect drops immediately into "Ready to connect"

[Madura Malwatte]

I have Anyconnect version 4.1.04011 (have tested version 4.2.02075 as well) running and recently I found I am unable to connect to the ASA. I am using windows 10 machine. You can see from the timestamp that after entering the credentials it drops immediately into "Ready to connect". 

19/04/2018
2:28:07 PM Ready to connect.
2:29:28 PM Contacting x.x.x.x.
2:29:36 PM Contacting x.x.x.x.
2:29:41 PM User credentials entered.
2:29:41 PM Ready to connect.
2:34:36 PM Contacting x.x.x.x.
2:34:44 PM Contacting x.x.x.x.
2:34:49 PM User credentials entered.
2:34:50 PM Ready to connect.

Has anyone seen this type of issue before? It was working fine previously. I have tried to disable IPv6 under the anyconnect network adapter and have also set Internet connection sharing to manual mode.

[GioGonza]

Hello @Madura Malwatte, 

In order to know whatis going on you will need to collect the DART file and share it, since it will be the only to really know what is happening. 

If you can share it I can help you with that.

HTH

Gio

[Marius Gunnerud]

Without seeing your configuration my first thought is that the AnyConnect client is not receiving an IP address.

Please post the full (sanitised) running configuration of your ASA.