Madura Malwatte
Enthusiast
Enthusiast
Member since ‎01-05-2006
‎10-19-2023

User Statistics

  • 375 Posts
  • 5 Solutions
  • 45 Helpful votes Given
  • 81 Helpful votes Received
Recent Badges
5 Accepted Solution
 30 Helpful Vote
50 Replies
1 Accepted Solution
10 Helpful Vote
20 Replies
1 Helpful Vote
10 Replies
5 Replies

User Activity

Interested to hear if everyone is using FMCv in HA set up now that this option is available since 6.7? The second FMCv does need to be licensed - so are people purchasing the additional license for HA or going with the old school method of a single F...
Have an FTD1010 that's been factory reset (currently not registered with an FMC), can get to the FDM instead.Its currently running version 6.4 and I need to get to 7.3. Hence I have opted to use the reimage guide found here as it means I can go direc...
Does the new 9300X platforms support co-located border/control plane function in SDA? This doc mentions it supports in control plane node scale table, but no mention in the table below it for border scale. https://www.cisco.com/c/en/us/products/colla...
Trying to get my head around how WLAN's advertised on Meraki AP's work in an SD-Access environment.  - Meraki AP connected to a fabric enabled SD-Access switch port - Meraki obviously doing local switching (flex connect mode), where data traffic for ...
ISE 3.0 Is it possible to use a loadbalancer to load-balance just the url portal redirect a guest user receives and not the full radius session and still work without issue? I.e: 1. Radius session from NAD (WLC) goes direct to PSNs without using load...
Community Statistics
Member Since ‎01-05-2006 04:48 PM
Date Last Visited ‎10-19-2023 10:52 AM
Posts 375
Total Helpful Votes Received 81
Helpful Votes From
Helpful Votes Given To