10-28-2011 05:52 PM - edited 02-21-2020 05:41 PM
Hi there, please forgive if I have missed any forum protocols as this is my first post.
I am trying to configure Anyconnect SSL VPN and it is killing me, I am able to connect to the VPN on a laptop, witch is able to download the anyconnect client from the ASA and I can also connect to the VPN using the Cisco anyconnect app but....... I am unable to ping any of my IP's that are on the inside of my ASA. Before posting here I have spent many hours on forums and watching videos on anyconnect SSL VPN creation and I am following it to the T but still no ping. Any help would be very much appreciated.
Inside 10.17.1.254/24
Outside 192.168.1.254/24
VPN Pool 10.99.1.1-50/24
Inside LAN 10.17.1.0/24
---------------------------------------------------------------
ASA Version 8.4(2)
!
hostname ciscoasa
enable password ft5r/Vn.VedHFe0u encrypted
passwd 2KFQnbNIdI.2KYOU encrypted
names
!
interface Ethernet0/0
switchport access vlan 2
!
interface Ethernet0/1
!
interface Ethernet0/2
!
interface Ethernet0/3
!
interface Ethernet0/4
!
interface Ethernet0/5
!
interface Ethernet0/6
!
interface Ethernet0/7
!
interface Vlan1
nameif inside
security-level 100
ip address 10.17.1.254 255.255.255.0
!
interface Vlan2
nameif outside
security-level 0
ip address 192.168.1.253 255.255.255.0
!
ftp mode passive
object network obj_any
subnet 0.0.0.0 0.0.0.0
object network NETWORK_OBJ_10.99.1.0_26
subnet 10.99.1.0 255.255.255.192
pager lines 24
logging asdm informational
mtu inside 1500
mtu outside 1500
ip local pool ACPool 10.99.1.1-10.99.1.50 mask 255.255.255.0
icmp unreachable rate-limit 1 burst-size 1
no asdm history enable
arp timeout 14400
nat (inside,outside) source static any any destination static NETWORK_OBJ_10.99.1.0_26 NETWORK_OBJ_10.99.1.0_26 no-proxy-arp route-lookup
!
object network obj_any
nat (inside,outside) dynamic interface
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
timeout tcp-proxy-reassembly 0:01:00
timeout floating-conn 0:00:00
dynamic-access-policy-record DfltAccessPolicy
user-identity default-domain LOCAL
http server enable
http 10.17.1.0 255.255.255.0 inside
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart warmstart
telnet timeout 5
ssh timeout 5
console timeout 0
dhcp-client client-id interface outside
dhcpd auto_config outside
!
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
webvpn
enable outside
anyconnect image disk0:/anyconnect-win-2.5.2014-k9.pkg 1
anyconnect enable
tunnel-group-list enable
group-policy GroupPolicy_ACSSLVPN internal
group-policy GroupPolicy_ACSSLVPN attributes
wins-server none
dns-server value 10.17.1.1
vpn-tunnel-protocol ssl-client
default-domain none
username Earth password YwTxEzMBQFaeRlOE encrypted
tunnel-group ACSSLVPN type remote-access
tunnel-group ACSSLVPN general-attributes
address-pool ACPool
default-group-policy GroupPolicy_ACSSLVPN
tunnel-group ACSSLVPN webvpn-attributes
group-alias ACSSLVPN enable
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
message-length maximum client auto
message-length maximum 512
policy-map global_policy
class inspection_default
inspect dns preset_dns_map
inspect ftp
inspect h323 h225
inspect h323 ras
inspect rsh
inspect rtsp
inspect esmtp
inspect sqlnet
inspect skinny
inspect sunrpc
inspect xdmcp
inspect sip
inspect netbios
inspect tftp
inspect ip-options
!
service-policy global_policy global
prompt hostname context
call-home reporting anonymous prompt 2
Cryptochecksum:48f9a08dc4ac36ac9bf227fb0df7080f
: end
ciscoasa#
10-29-2011 01:25 AM
A few things to add/change:
1) Remove:
nat (inside,outside) source static any any destination static NETWORK_OBJ_10.99.1.0_26 NETWORK_OBJ_10.99.1.0_26 no-proxy-arp route-lookup
and configure the following:
object network NETWORK_OBJ_10.17.1.0
subnet 10.17.1.0 255.255.255.0
nat (inside,outside) source static NETWORK_OBJ_10.17.1.0 NETWORK_OBJ_10.17.1.0 destination static NETWORK_OBJ_10.99.1.0_26 NETWORK_OBJ_10.99.1.0_26
2) Add: management-access inside
3) Add:
policy-map global_policy
class inspection_default
inspect icmp
4) Did you remove your default route? Didn't see that in the configuration.
Test to see if you can ping 10.17.1.254.
10-29-2011 05:40 AM
Hey Jennifer.
Thank you for the reply I have add/changed what you suggested but to the same out come, my client is able to connect but no ping. I am unable to ping both 10.17.1.254 or .1
Ref point 4 I have these routes, I thought this would be my default route for my remote clinet?
C 10.17.1.0 255.255.255.0 is directly connected, inside
S 10.99.1.1 255.255.255.255 [1/0] via 192.168.1.43, outside
C 192.168.1.0 255.255.255.0 is directly connected, outside
Below is a diagram of what I am tring to achive (thought I would start simple to avide problems...Doh)
Again any think you can sugget would help me greatly (I dont want to go back to OpenVPN)
ASA Version 8.4(2)
!
hostname ciscoasa
enable password ft5r/Vn.VedHFe0u encrypted
passwd 2KFQnbNIdI.2KYOU encrypted
names
!
interface Ethernet0/0
switchport access vlan 2
!
interface Ethernet0/1
!
interface Ethernet0/2
!
interface Ethernet0/3
!
interface Ethernet0/4
!
interface Ethernet0/5
!
interface Ethernet0/6
!
interface Ethernet0/7
!
interface Vlan1
nameif inside
security-level 100
ip address 10.17.1.254 255.255.255.0
!
interface Vlan2
nameif outside
security-level 0
ip address 192.168.1.253 255.255.255.0
!
ftp mode passive
object network obj_any
subnet 0.0.0.0 0.0.0.0
object network NETWORK_OBJ_10.99.1.0_26
subnet 10.99.1.0 255.255.255.192
object network NETWORK_OBJ_10.17.1.0
subnet 10.17.1.0 255.255.255.0
pager lines 24
logging asdm informational
mtu inside 1500
mtu outside 1500
ip local pool ACPool 10.99.1.1-10.99.1.50 mask 255.255.255.0
icmp unreachable rate-limit 1 burst-size 1
no asdm history enable
arp timeout 14400
nat (inside,outside) source static NETWORK_OBJ_10.17.1.0 NETWORK_OBJ_10.17.1.0 destination static NETWORK_OBJ_10.99.1.0_26 NETWORK_OBJ_10.99.1.0_26
!
object network obj_any
nat (inside,outside) dynamic interface
timeout xlate 3:00:00
timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02
timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00
timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00
timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute
timeout tcp-proxy-reassembly 0:01:00
timeout floating-conn 0:00:00
dynamic-access-policy-record DfltAccessPolicy
user-identity default-domain LOCAL
http server enable
http 10.17.1.0 255.255.255.0 inside
no snmp-server location
no snmp-server contact
snmp-server enable traps snmp authentication linkup linkdown coldstart warmstart
telnet timeout 5
ssh timeout 5
console timeout 0
management-access inside
dhcp-client client-id interface outside
dhcpd auto_config outside
!
threat-detection basic-threat
threat-detection statistics access-list
no threat-detection statistics tcp-intercept
webvpn
enable outside
anyconnect image disk0:/anyconnect-win-2.5.2014-k9.pkg 1
anyconnect enable
tunnel-group-list enable
group-policy GroupPolicy_ACSSLVPN internal
group-policy GroupPolicy_ACSSLVPN attributes
wins-server none
dns-server value 10.17.1.1
vpn-tunnel-protocol ssl-client
default-domain none
username Earth password YwTxEzMBQFaeRlOE encrypted
tunnel-group ACSSLVPN type remote-access
tunnel-group ACSSLVPN general-attributes
address-pool ACPool
default-group-policy GroupPolicy_ACSSLVPN
tunnel-group ACSSLVPN webvpn-attributes
group-alias ACSSLVPN enable
!
class-map inspection_default
match default-inspection-traffic
!
!
policy-map type inspect dns preset_dns_map
parameters
message-length maximum client auto
message-length maximum 512
policy-map global_policy
class inspection_default
inspect dns preset_dns_map
inspect ftp
inspect h323 h225
inspect h323 ras
inspect rsh
inspect rtsp
inspect esmtp
inspect sqlnet
inspect skinny
inspect sunrpc
inspect xdmcp
inspect sip
inspect netbios
inspect tftp
inspect ip-options
inspect icmp
!
service-policy global_policy global
prompt hostname context
call-home reporting anonymous prompt 1
Cryptochecksum:b50677f05219752d32a3ed7589c1738c
: end
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide