as-5350

[ricardo-morales]

hi can someone help, i need to set the clock internal in a E1 controller but i cant.

AS-5350

flash:c5350-is-mz.124-9.T1.bin

5350 Software (C5350-IS-M), Version 12.4(9)T1

it is configure

Framing is NO-CRC4, Line Code is HDB3, Clock Source is External.

[smothuku]

Hi ,

Use "tdm clock priority 1 slot/port " global command

reason :

Configuring Clocking

The time-division multiplexing (TDM) bus on the Cisco AS5350 and Cisco AS5400 backplane

can receive an input clock from one of four basic sources on the gateway:

1.CT1, CE1, and CT3 trunk cards

2.An external T1/E1 clock source feed directly through the Building Integrated Timing Supply (BITS) interface port on the motherboard

3.Free-running clock providing clock from an oscillator

check the below link.

http://cco/univercd/cc/td/doc/product/access/acs_serv/as5350/sw_conf/53swcg/54bas2.htm#xtocid31

http://www.cisco.com/en/US/products/sw/iosswrel/ps5187/products_command_reference_chapter09186a008017d90c.html#wp1140246

Hope it helps you.

Thanks,

satish

[ricardo-morales]

thanks

in the configuration i have this

tdm clock priority 1 external

tdm clock priority 2 3/0

but i want internal clock in specifically in

controller E1 3/2