06-15-2007 01:39 PM - edited 02-21-2020 03:06 PM
I setup VPN using the wizard and I can connect but I can't get to internal resources. I'm not sure if I need to add a route somewhere but I'm sure this is an easy one but I don't usually focus on Security.
06-15-2007 01:49 PM
06-15-2007 07:37 PM
The biggest problem I see from a glance, you should put your VPNPool in another subnet besides the inside network (192.168.1.0/24).
Also, your interface WirelessGuestLAN should be lower security level besides 100 (which is the same as your inside interface)
example:
ip local pool VPNPool 10.1.1.1-10.1.1.31 mask 255.255.255.224
!
access-list Inside_nat0_outbound extended permit ip any 10.1.1.0 255.255.255.224
!
access-list HPMVPN_splitTunnelAcl extended permit ip any 10.1.1.0 255.255.255.224
!
no access-list HPMVPN_splitTunnelAcl standard permit any
06-17-2007 01:59 PM
Thanks for the response Khary, I'll let you know how it goes.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide