02-10-2009 06:31 AM
Guys,
We have an office in Luxemburg connected to the Internet via a D-Link wireless router. We wanted to replace it with a Cisco 1801w router so we could setup a site-2-site vpn but when I connect the adsl line to the Cisco router the line is coming up. ATM interface status is always showing as down. Is there a different RJ11 cable pairing in Luxemburg or I am I missing something here?
Cheers
02-16-2009 04:13 PM
make sure the Encapsulation protocol configuration also.
The purple RJ-11-to-RJ-11 ADSL cable routers to the ADSL line.
ADSL Cable Pinouts
2-2
3-3
4-4
5-5
1 & 6 are not used
2&3 for data
02-17-2009 04:37 AM
I figured out what the problem is, it is ADSL over ISDN and not ADSLoPots, that is why I was not seeing any signal on the ATM.
Any how this information will be very handy when I go to Luxembourg this week to setup the VPN.
Many thanks mchin345
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide