10-04-2013 05:19 PM
Hi,
i have a pix configured inline. so cable modem --> cisco pix 525 with ios 8.0.4 --> member hosts
the pix serves as a dhcp server and router
looking to turn on remote access so that i can login from remotely to my network.
can someone outline the basic commands needed to set this up.
my understanding is there a couple of different modes, split tunnel and pure tunnel
any one would suffice to start.
jeff
10-13-2013 06:11 PM
this is what i did to enable remote access. i can successfully authenticate but no traffic passes. i can't ping any internal or external ip or get on the internet when connected.
hostname(config)#isakmp policy 1 authentication pre-share
hostname(config)#isakmp policy 1 encryption 3des
hostname(config)#isakmp policy 1 hash sha
hostname(config)#isakmp policy 1 group 2
hostname(config)#isakmp policy 1 lifetime 43200
hostname(config)#isakmp enable outside
hostname(config)#ip local pool testpool 10.1.1.20-10.1.1.254
hostname(config)#username testuser password 12345678
hostname(config)#crypto ipsec transform set FirstSet esp-3des esp-md5-hmac
hostname(config)#tunnel-group testgroup type ipsec-ra
hostname(config)#tunnel-group testgroup general-attributes
hostname(config-general)#address-pool testpool
hostname(config)#tunnel-group testgroup ipsec-attributes
hostname(config-ipsec)#pre-shared-key 44kkaol59636jnfx
hostname(config)#crypto dynamic-map dyn1 1 set transform-set FirstSet
jeff
10-15-2013 03:48 PM
BOINK
10-17-2013 08:27 AM
bump
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide