11-16-2020 04:21 AM
Helloo.
I am trying to reset the password of Cisco catalyst 2950 series switch. connected to my laptop via console cable (which is prolific PL2303 chipset supported) and at the boot time I pressed CTRL + BREAK from my keyboard, it does not respond and keep its POST. then tried special command >> break using putty , still the same. It seems not recognize the break signal. Baud rate is 9600 and Am I doing anything wrong here ?
Please help
Much appriciate
Thanks
Priyankara
Solved! Go to Solution.
11-16-2020 06:56 AM
Hi,
On the Cat 2950, you don't type the break sequence, you just have to hold the "mode" button on the front of the switch whilst it's booting.
Best, Leigh
11-16-2020 06:56 AM
Hi,
On the Cat 2950, you don't type the break sequence, you just have to hold the "mode" button on the front of the switch whilst it's booting.
Best, Leigh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide