I am trying to set up a Site-to-Site VPN network. Right now I am trying to make this work in the lab. I have the Internet port on the Linksys connected directly to port 0 on the cisco which was set up as the internet port.
My setup is as follows:
Remote Site
Laptop 1 - IP Address 192.168.2.100 255.255.255.0 GW 192.168.2.1
Router 1 (Linksys BEFSX41) - LAN IP Address 192.168.2.1 255.255.255.0
WAN IP Address 209.168.145.49 255.255.255.0 GW 209.168.145.50
Host Site
Laptop 2 - IP Address 192.168.1.100 255.255.255.0 GW 192.168.1.1
Router 2 (Cisco ASA 5505) - LAN 0 IP Address 192.168.1.1 255.255.255.0
WAN IP Address (Port 0) 209.168.145.50 255.255.255.0
My problems:
I am using ASDM 5.2 to configure the ASA router. With the configuration I currently have my linksys is not able to establish a VPN connection. The ASA Log reported via the ASDM is as shown in the ciscolog.txt attachment.
My linksys log is as shown in the linksyslog.txt attachment.
I also tried to create a Cisco VPN client connection using the cisco client software and connected one of the laptops directly to the internet port (port 0) on the cisco router and was not able to make a connection with that either. I used the ASDM VPN wizard to attempt to set up both the Site-to-site as well as the remote connection scenarios. This has been unsuccesful in both instances.
The only one I am really concerned with getting to work is the site-to-site.
My current cisco configuration is shown in the cisco.txt attachment.
If anyone has any input I would greatly appreciate it. I have been through the cisco manuals as well as scouring the internet and am unable to find an answer.
I have attached 3 files, the cisco log (ciscolog.txt), linksys log (linksyslog.txt) and cisco config (cisco.txt) as text files.
Thanks.
Sean
