cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
35883
Views
0
Helpful
3
Replies

Changing XML profile in Mac

natalie011
Level 1
Level 1

Hello, 

 

I installed Anyconnect when I worked for a different university.  When it starts up, it always tries to connect with that university.   I would like to change the server profile to be my current university's server.  How do I do that?  I downloaded the software from them, but it won't install because I have a newer version already installed.  I see the .xml file.  Could I just move this into a place or replace an old .xm file?  Where would would that be? 

I am using OS X Yosemite: 10.10.3 and Cisco AnyConnect version 3.1.05170

Thank you, 

 

 

1 Accepted Solution

Accepted Solutions

rvarelac
Level 7
Level 7

Hi natalie011

 

The XML should be located on /opt/cisco/anyconnect/profile 

You can delete the older profile to solve this issue.

 

Hope it helps

-Randy- 

View solution in original post

3 Replies 3

rvarelac
Level 7
Level 7

Hi natalie011

 

The XML should be located on /opt/cisco/anyconnect/profile 

You can delete the older profile to solve this issue.

 

Hope it helps

-Randy- 

Thanks.   I found it, deleted the old profile and put in the new xml file,  but nothing changed.  Perhaps it will take a restart? 

 

Natalie

Restarting AnyConnect should cause it to load the new profile.

You can use a newer client just fine when the headend ASA has an older version of AnyConnect package on it.