Earlier today, while doing a few very basic configurations to an up and running 804, I suddenly received this console message: Note: IOS boot is disabled, router will boot to TinyROM
upon reboot (not recommend for remotely administered routers).
Now, on reload the 804 boots to ROMMON but the commands I really need to use at boot# seem useless. Below is a partial list of the results of trying various commands. Help?
boot# list
Status Size Dev Name
------ 48K flash TinyROM-1.4(1)
---r-x 2994K flash c800-y6-mw.121-3.XG4
5120K free 8192K total
boot# load
load: succeeded.
boot# set
set baud =9600
set data-bits =8
set parity =none
set stop-bits =1
set console-flags =0
set mac-address =0002.1762.CEE2
set unit-ip =0.0.0.0
set serv-ip =0.0.0.0
set netmask =0.0.0.0
set gate-ip =0.0.0.0
set pkt-timeout =4
set tftp-timeout =16
set boot-action =none
set file-name =""
set watchdog =off
set prompt ="boot"
set ios-conf =0
boot# set boot-action flash
boot-action: failed, "missing value"
boot# set boot-action ?
boot-action: failed, "missing value"
boot# set boot-action
boot-action: failed, "missing value"
boot# set file-name c800-y6-mw.121-3.XG4
file-name: failed, "missing value"
boot# set file-name c800-y6-mw.121-3.XG4
file-name: failed, "missing value"
